In apartment complexes this is now the most common way of changing locks on a door.
Changing door locks do it yourself.
Step 2 remove the screws from two halves of lock.
Door lock installation 1.
Step 2 remove the old lock.
Then remove each side s door knob by pulling them away from the door.
Purchase the same lock from a local hardware store.
Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening.
Use a phillips head screwdriver to unfasten the two or three screws located on the inside knob plate.
Test the latch operation and the locking.
As stated above you need access to both sides of the door at the same time when changing locks.
This allows you to pull the door.
Remove the screws from the old lock on the inside of the door.
Rekeying involves realigning the pins and springs in the inner workings of the lock in order to match the lock.
Installing the new lock is an.
Remove the old deadbolt.
You may also need to use a wire tool or a paper clip.
Go to the store and purchase a new lock.
Changing locks on doors.
Remove the old lock.
Install your new lockset making sure that the keyed section is on the outside.
Measure the back set of the door by measuring from the door latch to the middle of the door knob.
How to change a lock step 1.
Insert the pins and reassemble the lock dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to.
Once the new pins are in reverse the steps to reassemble the lock.
Open the door and.
In some cases door latch plate mortises might need to be cut or enlarged.
Step 1 purchase a new lock.
Step 4 insert new tongue plate.
Chisel out any uneven recesses in the latch so that your new latch will fit perfectly.
Then screw in the new door knob piece and tighten it with your screwdriver.
You will want to find one that is keyed on only.
Step 3 install the new lock.
Put the two pieces together and then screw in the door piece.
Changing the lock yourself examine the latch of the door to determine what brand of lock it is.
Before you begin make sure you have a new door lock set and a screwdriver or drill.
Step 1 prop the door open.
Replacing the lock on a front door.
Purchase a new lock.
Begin by removing the screws from the door knob on the interior side of your door.
Now put the door handle together in the opposite way that you took it apart.
Step 3 remove screws from tongue plate.
